How to make a fishing Elasticate rod

When playing a fish as that is absorbed with a rod of the discharge of fish fight through the internal elastic hook. Type used depends on the size of the species, which is angling for position poste-pescadores. Small fish, Golden silver small, Roach, "Raven", need a size 3 or 4 elastic. When it's over, tench, carp, a heavy elastic with a rating of 8, 10 or even 12 would be the right choice.

Around the Pol elasticate, need the following equipment: elastic of the number that you need. walk a plug at the base of the section bar. a cat at the top of PTFE insert the dipstick; a connection with the elastic to end fighting; a feeder of elastic thin wire used for elastikfaden through the pole sections; Modeling of knife and wet abrasive paper / dry, which is used to purify all vertices and edges. A special plug the tractor can also be used with certain plug, so it can easily be removed at a later date.

How to make a bar of Elasticate

1. A number eight elastic was selected here as a tent pole for elastic small Lor position. Besides elastic are a stopper, stopper, tractor, PTFE tip and a plug.

2. How is the post with a strong degree of elastic mounted should tip is cut, they are responsible for this. If the tip was in its entire length, the possibility that can be aligned when a large tent is hooked.

3. Result of the outer wall of the tip of the rod. Once the rod Assembly reached the top, it can be started. Section cutting board should be cleaned then fine with a small piece; Abrasive paper.

4 Tip PTFE Bush is inserted at the end of the tip. You will find that it can be trial and error is the only way you are going to get a snug fit. If this is the case, cut a small piece of the section at a time until the right fit for the cover of PTFE tip.

5. Thread the wire feeder elastic in the tip area at the base of the second or third section of the bar. At the end of the feeder has a diamond eye. It's elastic handle while it came out through the Interior of the bar.

6. Once the elastic through the interior walls of the pol won the CAP sections can be equipped. A simple knot to make a loop that can be connected with the plug may be used.

7. Some things come with a plug remover. As post a type of post on the plug in the wall of the bar is added above. At some point there will be retrieved plug until he to change elastic.

8. Remove the tip of the elastic end, tighten until a small amount of voltage is placed. The connection must be equipped for this size of the elastic so that the elastic is used only under voltage.

9 Thread the connection hoses and then the elastic through the hole in the CAP. Elastic in connection with a granny knot to secure. Check if the node does not slip.

10. With the node slides ensured the sleeves over the connector, to protect the node. Now test the elastic for a soft, pole position of tip hump-free output.

11. In order to connect a bar for the outlet store, go back, slide the hose and place the loop at the top of the platform in the hook. Close once available to fill the sleeve to the line too.